DeltaXStudio — Overview

On this page Where to start The Pick & Place setup path When the application changes

DeltaXStudio — Overview

Choose a guide for the work you need to do. The four-step setup takes a new camera-based Pick & Place installation through its first successful pick. Blockly programming and daily operation have their own guides.

Where to start

Set up Pick & Place

Connect the hardware, calibrate the camera and robot, configure detection, and test picking. Follow this path when commissioning a new camera-based application.

Start with System Setup →

Write a Blockly program

Build a custom movement sequence or detection task. Connect and check the hardware first; add Calibration and Vision when your program uses camera-based picking.

Open Blockly Programming →

Operate an existing setup

Open the interface, check the system, and run or stop the application that has already been tested. You do not need to repeat calibration or training every day.

Open Daily Operation →

The Pick & Place setup path

Stage What you configure Ready to continue when…
1. System Setup Network access and installed hardware. The intended robot, camera, and any required conveyor/encoder respond correctly.
2. Calibration The relationship between camera, robot, and conveyor coordinates. Calibration completes successfully and the corrected image and crop are correct.
3. Vision AI or color detection, with optional Template Matching. Each object has a stable detection with the intended center, orientation, and class.
4. Pick & Place Working heights, destinations, motion settings, and the selected task. Low-speed tests reliably pick, transfer, and release objects at several positions.

In Calibration and Vision, choose one method that fits your application. The methods are alternatives, not additional steps to complete in order. Each method guide leads back to the next setup stage.

Blockly is available whenever you need it. Color filtering uses Blockly during Vision setup; custom picking logic uses it during Pick & Place setup. Built-in AI picking does not require learning Blockly first.

When the application changes

Return to the part affected by the change rather than repeating the whole setup.

Change Revisit
Network or installed hardware System Setup
Camera, robot, or conveyor moved relative to one another Calibration, then verify detection and picking
Object appearance, lighting, classes, or detection method Vision, then verify class-to-destination mapping and picking
Tool, object height, destination, or motion settings Pick & Place and any affected working-height settings
Program sequence or branching logic Blockly Programming, then test the updated task

After the application has passed its setup tests, use Daily Operation for routine checks and operation.

Found something that could be clearer?Suggest an edit

What are you working on?

Try a command like G28, a model, or a topic like wiring.