DeltaXStudio — Calibration

On this page Stationary objects Moving objects on a conveyor After calibration

DeltaXStudio — Calibration

Choose the setup that matches your installation. Each guide includes its own preparation, settings, capture steps, and checks. Follow only the guide you need.

Stationary objects

Use this when the objects stay still inside both the camera view and robot reach.

Static calibration

Capture two reference points on a fixed board. The conveyor, if present, stays stopped.

No encoder requiredNo calibration camera

Open guide →

Moving objects on a conveyor

All conveyor methods require encoder feedback connected to DeltaXStudio. First choose who controls the conveyor, then whether a calibration camera is installed.

DeltaXStudio controls the conveyor

Fully automatic

The software controls belt movement and uses the calibration camera to align robot points.

Encoder requiredCalibration camera

Open guide →

Manual robot points

The software controls the belt. You align the tool and capture each robot point.

Encoder requiredNo calibration camera

Open guide →

Operator controls the conveyor externally

With calibration camera

You start and stop the belt when prompted. The camera handles robot-point alignment.

Encoder requiredCalibration camera

Open guide →

With manual robot points

You control the belt and align the tool to capture the reference points.

Encoder requiredNo calibration camera

Open guide →

The selected guide contains the working-height and crop instructions for that setup. There is no need to read the other methods.

After calibration

Check the completion message and camera crop, then continue to Vision. If calibration stops or fails, use the troubleshooting section at the end of your selected guide.

Found something that could be clearer?Suggest an edit

What are you working on?

Try a command like G28, a model, or a topic like wiring.